KELLY-MOORE PAINT CO INC -- 1610-SERIES (ALL COLORS), SAT-N-SHEEN LATEX (SUPDAT)  -- 8010-00N064961
<pre>=====================  Product Identification  =====================

Product ID:1610-SERIES (ALL COLORS), SAT-N-SHEEN LATEX (SUPDAT)
MSDS Date:09/12/1994
FSC:8010
NIIN:00N064961
=== Responsible Party ===
Company Name:KELLY-MOORE PAINT CO INC
Address:1015 COMMERCIAL ST
City:SAN CARLOS
State:CA
ZIP:94070
Country:US
Info Phone Num:415-592-8337
Emergency Phone Num:800-424-9300(CHEMTREC)
Preparer's Name:JULIAN SCHAFER
CAGE:0BBH6
=== Contractor Identification ===
Company Name:KELLY-MOORE PAINT CO INC
Address:1015 COMMERCIAL ST
Box:City:SAN CARLOS
State:CA
ZIP:94070
Country:US
Phone:415-592-8337
CAGE:0BBH6

=============  Composition/Information on Ingredients  =============

Ingred Name:NON-HAZARDOUS INGREDIENTS
Fraction by Wt: <1%
OSHA PEL:N/K 
ACGIH TLV:N/K 

Ingred Name:3,5,7-TRIAZA-1-AZONIAADAMANTANE, 1-(3-CHLOROALLYL)-,
    CHLORIDE; (PAINT PRESERVATIVE)
CAS:4080-31-3
RTECS #:XX8450000
OSHA PEL:N/K 
ACGIH TLV:N/K 

Ingred Name:TITANIUM OXIDE; (TITANIUM DIOXIDE)
CAS:13463-67-7
RTECS #:XR2275000
OSHA PEL:15 MG/M3 TDUST
ACGIH TLV:10 MG/M3 TDUST

Ingred Name:SILICATES
OSHA PEL:N/K 
ACGIH TLV:N/K 

Ingred Name:CALCIUM CARBONATE
CAS:1317-65-3
RTECS #:EV9580000
OSHA PEL:15 MG/M3 TDUST
ACGIH TLV:10 MG/M3 TDUST

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:ACUTE:DIZZINESS, HEADACHE, NAUSEA,
    CONFUSION, IRRITATION TO UPPER RESPIRATORY TRACT, UNCONSCIOUSNESS,
    SKIN & EYE IRRITATION. CHRONIC:NONE KNOWN.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE KNOWN. SEE YOUR PHYSICIAN FOR
    SPECIFIC MEDICAL OPINION REGARDING YOUR CONDITION.

=======================  First Aid Measures  =======================

First Aid:INHAL:REMOVE TO FRESH AIR. RESTORE BREATHING. CONSULT MD.
    EYE:FLUSH W/LARGE VOLUMES OF WATER FOR AT LEAST 15 MINUTES. GET
    MEDICAL ATTENTION. SKIN:WIPE OFF W/RAG. WASH THOROUGHLY W/SOAP &
    WATER. INGEST :CONSULT HOSPITAL EMERGENCY ROOM OR POISON CONTROL
    CENTER IMMEDIATELY.

=====================  Fire Fighting Measures  =====================

Flash Point:NONE
Extinguishing Media:MEDIA SUITABLE FOR SURROUNDING FIRE .
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
    EQUIPMENT .
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY EXPLODE (DUE TO
    BUILD-UP OF STEAM PRESSURE) WHEN EXPOSED TO EXTREME HEAT.

==================  Accidental Release Measures  ==================

Spill Release Procedures:VENTILATE AREA TO PREVENT BUILD-UP OF VAPORS.
    FOR SMALL SPILLS, SOAK UP W/ABSORBANT. FOR LARGER SPILLS, DIKE AREA
    W/ABSORBENT MATERIAL & SCOOP UP LIQUIDS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE UPRIGHT IN SEALED CONTAINERS
    AWAY FROM HEAT & FLAME.
Other Precautions:THIS PRODUCT CONTAINS PIGMENTS SUCH AS TITANIUM
    DIOXIDE, SILICATES & CALCIUM CARBONATE THAT MAY BE NUISANCE DUST
    HAZARDS IN THEIR ORIGINAL DRY POWDER FORM BUT ARE NOT HAZARDOUS IN
    WET PAINT.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:USE NIOSH/MSHA APPRVD PARTICLE MASK (TC-21C) TO
    AVOID BRTHG SPRAY MIST/SANDING DUST IF LOC VENT IS ADEQ TO KEEP VAP
    CONCS W/IN ACCEPT (TLV) LIMS. IF LOC VENT IS NOT SUFFICIENT/WHERE
    EXPOS LIMS ARE EXC EEDED, WEAR SUITABLE, PROPERLY (SUPDAT)
Ventilation:LOCAL CROSS-VENT OR MECHANICAL EXHAUST SUFFICIENT TO KEEP
    ALL HAZARDOUS VAPOR CONCENTRATIONS BELOW PRESCRIBED LIMITS.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
    ANSI DESIGN CRITERIA .
Work Hygienic Practices:REMOVE & WASH CONTAMINATED CLOTHING BEFORE
    REUSE.
Supplemental Safety and Health
MFR'S TRADE NAME/PART NO:WALL/TRIM FINISH. RESP PROT:FITTED NIOSH/MSHA
    APPRVD RESP (TC-23C OR BETTER) FOR ORGANIC VAPORS W/DUST FILTER AS
    NEEDED.

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:212F,100C
Vapor Density:LTR/AIR
Spec Gravity:1.32 
Evaporation Rate &amp; Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:60-65

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Hazardous Decomposition Products:MAY PRODUCE HAZARDOUS FUMES WHEN
    HEATED TO DECOMPOSITION AS IN WELDING.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSAL MUST BE I/A/W FEDERAL, STATE & LOCAL
    REGULATIONS . DISCARD IN LANDFILL IN SEALED METAL CONTAINERS AWAY
    FROM HEAT & FLAME & I/A/W LOCAL REGULATIONS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.